光子晶体光纤温度压力传感器

提出了一种在高温环境下同时测量温度和气压的光子晶体光纤温度压力传感器.在普通单模光纤和光子晶体光纤之间熔接一段空心光纤构成干涉结构.空心光纤段构成非本征法布里-珀罗干涉仪,利用光子晶体光纤的微孔与外界相通,通过气体折射率变化来测量环境中的气压变化;光子晶体光纤段构成本征法布里-珀罗干涉仪,利用热膨胀效应和热光效应来测量环境中的温度.传感器的解调通过自制的白光干涉解调仪实现,实验通过测量腔长得到被测环境的温度和气压.在不同温度和气压环境下,对腔长分别为306μm和1535μm的温度压力光纤传感器进行连续测量.实验结果表明,传感器能够在28~800℃的温度下和0~10 MPa的气压下稳定工作,测量范围内温度灵敏度可达17.4 nm/℃,压力灵敏度随温度增加而降低,在28℃时可达1460.5 nm/MPa.     

Rapid analysis of ultraviolet filters using dispersive liquid–liquid microextraction coupled to headspace gas chromatography and mass spectrometry

An ionic‐liquid‐based in situ dispersive liquid–liquid microextraction method coupled to headspace gas chromatography and mass spectrometry was developed for the rapid analysis of ultraviolet filters. The chemical structures of five ionic liquids were specifically designed to incorporate various functional groups for the favorable extraction of the target analytes. Extraction parameters including ionic liquid mass, molar ratio of ionic liquid to metathesis reagent, vortex time, ionic strength, pH, and total sample volume were studied and optimized. The effect of the headspace temperature and volume during the headspace sampling step was also evaluated to increase the sensitivity of the method. The optimized procedure is fast as it only required ∼7–10 min per extraction and allowed for multiple extractions to be performed simultaneously. In addition, the method exhibited high precision, good linearity, and low limits of detection for six ultraviolet filters in aqueous samples. The developed method was applied to both pool and lake water samples attaining acceptable relative recovery values.     

考虑制动力影响的大型客车舒适性分析

利用有限元法和动力平衡原理,建立了具有层间接触的沥青路面和13个自由度的大型客车人体三维模型。以不平顺作为激励,随机模拟车流分布,在不同制动情况下,从时域和频域两方面分析人-车-路耦合振动下车辆和人体的动力响应。时域分析采用客观评价标准和主观烦恼率相结合的方法,频域分析考虑人体共振、人的心理和生理因素。结果表明:随着制动力增大,人体的竖向加速度幅值不变,俯仰、侧倾加速度幅值都增大,但是俯仰加速度增幅远大于侧倾加速度的情况,人的舒适性变差,烦恼率增高;在紧急制动时,主频段对人体共振、心理和生理产生的影响很小,但是次主频段与人体某些器官固有频段重合,对人体共振、心理和生理产生的影响是不容忽视的。     

Opposed type double stage cell for Mbar pressure experiment with large sample volume

ABSTRACT

A new opposed type double-stage large volume cell has been developed to compress large volume samples to more than 100?GPa (Mbar) pressure. A pair of second-stage diamond anvils is introduced into the first-stage Paris–Edinburgh press. The double-stage large volume cell allows the generation of ultrahigh pressures using a large culet diameter of the second-stage diamond anvils (diameters of 0.5–1.2?mm). Pressure generation up to 131?GPa has been achieved by using the culet diameter of 0.5?mm. Sample volume of the double-stage large volume cell can be more than ～100 times larger than that of conventional Mbar experiment using a diamond anvil cell. The double-stage large volume cell has a large opening in the horizontal plane for X-ray measurements, which is particularly suited for the multi-angle energy dispersive X-ray diffraction measurement, thus opening a new way of in situ structural determinations of amorphous materials at Mbar pressures.     

基于DIS数字信息化系统对透光物质透光性能的研究

采用DIS数字信息化系统,对不同浓度的蓝墨水溶液在激光光源照射下的透射平均照度及照度分布图像进行实验研究,得到了平均照度值随溶液浓度变化的规律。对不同颜色塑料膜片对白炽灯光源透过照度值及照度分布图像进行实验研究得到及其相关之规律。     

Heat Transfer Enhancement by Using Copper–Water Nanofluid Flow Inside a Pin Channel

Influences of simultaneous utilization of pin channel and copper–water nanofluid on performance of plate-fin heat exchangers were experimentally explored and compared with results obtained for the base fluid flow inside a plain channel. Experimental results clearly indicate that compared with the plain channel, the pin channel significantly improves the thermal-hydraulic performance of the plate-fin heat exchanger, about 38%. In addition, the heat transfer coefficient as well as pressure drop are increased by using the nanofluids instead of the base fluid. Noticeable average performance factor of 1.65 is obtained for the simultaneous utilization of pin channel and nanofluid inside the plate-fin heat exchanger.     

为什么要引入溶剂的渗透因子

阐明了引入溶剂渗透因子的必要性,较详细地介绍了两种渗透因子及它们间的关系。     

Potts models with magnetic field: Arithmetic,geometry, and computation

We give a sheaf theoretic interpretation of Potts models with external magnetic field, in terms of constructible sheaves and their Euler characteristics. We show that the polynomial countability question for the hypersurfaces defined by the vanishing of the partition function is affected by changes in the magnetic field: elementary examples suffice to see non-polynomially countable cases that become polynomially countable after a perturbation of the magnetic field. The same recursive formula for the Grothendieck classes, under edge-doubling operations, holds as in the case without magnetic field, but the closed formulae for specific examples like banana graphs differ in the presence of magnetic field. We give examples of computation of the Euler characteristic with compact support, for the set of real zeros, and find a similar exponential growth with the size of the graph. This can be viewed as a measure of topological and algorithmic complexity. We also consider the computational complexity question for evaluations of the polynomial, and show both tractable and NP-hard examples, using dynamic programming.